Without this change we spam the kernel log on every packet received on
any other interface when an interface has been added, but is not yet
active, ie UP.
Signed-off-by: Simon Wunderlich <siwu@hrz.tu-chemnitz.de>
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Break up a lot of the big functions up into many smaller ones. This
helps with readability and there is now a lot less code squashed
against the right hand margin.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Acked-by: Marek Lindner <lindner_marek@yahoo.de>
Acked-by: Simon Wunderlich <simon.wunderlich@s2003.tu-chemnitz.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
batman-adv used its own logging infrastructure. Replace this with
standard kernel logging, printk(), with compile time and runtime
options to enable/disable different debug levels.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
This almost trivial patch replaces the hardcoded values for the vendor and
device ids with defines, as they are used in drivers/hid/hid-ids.h
For me this seems to be more consistent, however as drivers/hid/hid-ids.h
is not within the default include directory I had to redefine the defines here
(maybe move the hid-ids.h to include/linux ?)
Signed-off-by: Peter Huewe <peterhuewe@gmx.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Rearrange code and cleanup the information to get rid of checkpatch.pl
line > 80 chars complaints.
Signed-off-by: Ameya Palande <2ameya@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Uncompiled. Doesn't currently build anyway.
Converted MAC_FMT to %pM
Converted some %02x%02x%02x%02x%02x%02x to %pm
Converted MAC_ARG to direct use
Removed MAC_FMT and MAC_ARG macros
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Use pci_set_consistent_dma_mask() in the case of 64-bit consistent allocations.
Signed-off-by: Denis Kirjanov <kirjanov@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Use PCI_DEVICE_TABLE: defines array as const and puts
it into the __devinitconst section.
Signed-off-by: Denis Kirjanov <kirjanov@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
No need to check pointer expicitly since it has been done in debugfs_remove()
Signed-off-by: Denis Kirjanov <kirjanov@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Unable to build both drivers at the same time due to classing variables that should be declared static but aren't.
Signed-off-by: Martyn Welch <martyn.welch@gefanuc.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Functionality for master RMW and location monitors has been implemented.
Remove the commented out structures from the original codebase.
Signed-off-by: Martyn Welch <martyn.welch@gefanuc.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Geographical addressing only works if the VME backplane supports it. There
are a large number of old backplanes which do not support geographical
addressing. These boards will generally report a slot ID of zero - which is
an invalid ID in the slot numbering scheme.
Allow the geographical address to be over-ridden on the ca91c142 so that a
slot ID can be provided manually in these circumstances.
Signed-off-by: Martyn Welch <martyn.welch@gefanuc.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Geographical addressing only works if the VME backplane supports it. There
are a large number of old backplanes which do not support geographical
addressing. These boards will generally report a slot ID of zero - which is
an invalid ID in the slot numbering scheme.
Allow the geographical address to be over-ridden on the tsi148 so that a
slot ID can be provided manually in these circumstances.
Signed-off-by: Markus Kraemer <mkraemer@e18.physik.tu-muenchen.de>
Signed-off-by: Martyn Welch <martyn.welch@gefanuc.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
*apdbg.c: use NULL pointer instead of 0 interger. Also make two functions private.
Signed-off-by: Thiago Farina <tfransosi@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
cppcheck found that ctrl_pmsm is leaked if the open operation fails.
Signed-off-by: Eric Sesterhenn <eric.sesterhenn@lsexperts.de>
Signed-off-by: Pavel Machek <pavel@ucw.cz>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Add missing files/includes neccessary for Dream compilation. Mark
flash support as broken -- it is not present on released Dream, anyway.
Signed-off-by: Pavel Machek <pavel@ucw.cz>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
cleanup printk() warnings for including the facility level.
cleanup add a printk("\n") to terminate the print for the non-error case.
Signed-off-by: Bruce Beare <bbeare1@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
Set the PCI CLS early in the boot process to prevent
device failures. In pcibios_set_master use the new
pci_cache_line_size instead of a hard-coded value.
Signed-off-by: Carlos O'Donell <carlos@codesourcery.com>
Reviewed-by: Grant Grundler <grundler@google.com>
Signed-off-by: Kyle McMartin <kyle@redhat.com>
Trailing semicolon causes compilation involving out_le32() to fail.
Signed-off-by: Steven J. Magnani <steve@digidescorp.com>
Signed-off-by: Michal Simek <monstr@monstr.eu>
I create wrong asm code but none test shows that this part of code is wrong.
I am not convinces that were good idea to create asm optimized macros
for caches. The reason is that there is not optimization with previous code
that's why make sense to add old code and do some benchmarking which
functions are faster.
Signed-off-by: Michal Simek <monstr@monstr.eu>
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6:
net: bug fix for vlan + gro issue
tc35815: Remove a wrong netif_wake_queue() call which triggers BUG_ON
cdc_ether: new PID for Ericsson C3607w to the whitelist (resubmit)
IPv6: better document max_addresses parameter
MAINTAINERS: update mv643xx_eth maintenance status
e1000: Fix DMA mapping error handling on RX
iwlwifi: sanity check before counting number of tfds can be free
iwlwifi: error checking for number of tfds in queue
iwlwifi: set HT flags after channel in rxon
Traffic (tcp) doesnot start on a vlan interface when gro is enabled.
Even the tcp handshake was not taking place.
This is because, the eth_type_trans call before the netif_receive_skb
in napi_gro_finish() resets the skb->dev to napi->dev from the previously
set vlan netdev interface. This causes the ip_route_input to drop the
incoming packet considering it as a packet coming from a martian source.
I could repro this on 2.6.32.7 (stable) and 2.6.33-rc7.
With this fix, the traffic starts and the test runs fine on both vlan
and non-vlan interfaces.
CC: Herbert Xu <herbert@gondor.apana.org.au>
CC: Patrick McHardy <kaber@trash.net>
Signed-off-by: Ajit Khaparde <ajitk@serverengines.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
* 'release' of git://git.kernel.org/pub/scm/linux/kernel/git/lenb/linux-acpi-2.6:
ACPI: Be in TS_POLLING state during mwait based C-state entry
ACPI: Fix regression where _PPC is not read at boot even when ignore_ppc=0
acer-wmi: Respect current backlight level when loading
* 'drm-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/airlied/drm-2.6:
drm/vmwgfx: Fix queries if no dma buffer thrashing is occuring.
drm/nv50: fix vram ptes on IGPs to point at stolen system memory
drm/nv50: fix instmem binding on IGPs to point at stolen system memory
drm/nv50: improve vram page table construction
drm/nv50: more efficient clearing of gpu page table entries
drm/nv50: make nv50_mem_vm_{bind,unbind} operate only on vram
drm/nouveau: Fix up pre-nv17 analog load detection.
Revert the change made to arch/ia64/sn/kernel/setup.c by commit
204fba4aa3 as it breaks the build.
Fixing the build the b94b08081f way
breaks xpc because genksyms then fails to generate an CRC for
per_cpu____sn_cnodeid_to_nasid because of limitations in the
generic genksyms code.
Signed-off-by: Hedi Berriche <hedi@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
The netif_wake_queue() is called correctly (i.e. only on !txfull
condition) from txdone routine. So Unconditional call to the
netif_wake_queue() here is wrong. This might cause calling of
start_xmit routine on txfull state and trigger BUG_ON.
This bug does not happen when NAPI disabled. After txdone there
must be at least one free tx slot. But with NAPI, this is not
true anymore and the BUG_ON can hits on heavy load.
In this driver NAPI was enabled on 2.6.33-rc1 so this is
regression from 2.6.32 kernel.
Reported-by: Ralf Roesch <ralf.roesch@rw-gmbh.de>
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch adds a new vid/pid to the cdc_ether whitelist.
Device added:
- Ericsson Mobile Broadband variant C3607w
Signed-off-by: Torgny Johansson <torgny.johansson@gmail.com>
--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Signed-off-by: David S. Miller <davem@davemloft.net>
Andrew Morton wrote:
>> >From ip-sysctl.txt file in kernel documentation I can see following description
>> for max_addresses:
>> max_addresses - INTEGER
>> Number of maximum addresses per interface. 0 disables limitation.
>> It is recommended not set too large value (or 0) because it would
>> be too easy way to crash kernel to allow to create too much of
>> autoconfigured addresses.
^^^^^^^^^^^^^^
>> If this parameter applies only for auto-configured IP addressed, please state
>> it more clearly in docs or rename the parameter to show that it refers to
>> auto-configuration.
It did mention autoconfigured in the text, but the below makes it more obvious.
More clearly document IPv6 max_addresses parameter.
Signed-off-by: Brian Haley <brian.haley@hp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Check for error return from pci_map_single/pci_map_page and clean up.
With this and the previous patch the driver was able to handle a significant
percentage of errors (I set the fault injection rate to 10% and could still
download large files at a reasonable speed).
Signed-off-by: Anton Blanchard <anton@samba.org>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This reverts commit fb1e75389b.
"Benjamin S." <sbenni@gmx.de> reports that the patch in question
causes a big drop in sequential throughput for him, dropping from
200MB/sec down to only 70MB/sec.
Needs to be investigated more fully, for now lets just revert the
offending commit.
Conflicts:
include/linux/blkdev.h
Signed-off-by: Jens Axboe <jens.axboe@oracle.com>
Andrew Lunn
Peter Huewe
Ameya Palande
Joe Perches
kirjanov@gmail.com
Martyn Welch
Roel Kluin
Thiago Farina
Huang Weiyi
Pavel Machek
Bruce Beare
Linus Torvalds
Carlos O'Donell
Steven J. Magnani
Michal Simek
Ajit Khaparde
Hedi Berriche
David S. Miller
Atsushi Nemoto
Torgny Johansson
Brian Haley
Lennert Buytenhek
Anton Blanchard
Jens Axboe